All Locations & Contacts

 
 
Share

Internal Auditor training Programme for AS 9100 Rev C

(QMS Requirements for Aviation, Space and Defence Organisation)

Introduction:

AS9100 is a widely adopted and standardized quality management system for the aerospace industry.

AS9100 Rev C replaces the earlier AS 9100 Rev B and fully incorporates the current version of ISO 9001, while adding additional requirements relating to quality and safety. Major aerospace manufacturers and suppliers worldwide require compliance and/or registration to AS9100 as a condition of doing business with them. AS9100 Revision C was released in January, 2009.

The International Aerospace Quality Group (IAQG) released revision C to AS9100 Aerospace Standard for the aviation, space, and defence industries. The new requirements are intended to make significant improvements in quality and reductions in cost throughout the value stream. AS 9100 Standard includes several new requirements and clauses that focus on planning, project management, risk management and configuration management etc.

Because of this revision in the AS9100 Aerospace Standard, competence of internal auditors is the most important factor for ensuring effective implementation of the AS 9100 standard requirements. AS 9100 internal auditors require understanding of the standard, stake holder requirements, statutory and regulatory requirements, skill of auditing, and finally the application of these in most complex situations.

Objective

This Internal Auditor training programme empowers employees to identify any gaps that challenge the effectiveness of organisation’s quality management system.

The training program will also provide both technical knowledge and practical skills essential to become a competent internal auditor for Quality management system Requirements for Aviation, Space and Defense Organisation.

This course is designed to:

  • Explain the intent and requirement of each clause of AS9100 Rev C
  • Describe the documentation required by AS9100 Rev C and the interrelationships between the quality manual, procedures, quality planning, policy and objectives
  • Describe the requirements of the current revision of ISO 19011 as applicable to the audit process, with emphasis on Process Approach
  • Provide detailed knowledge of the auditing process including the role and responsibility of internal auditors
  • Audit reporting including Non-Conformity Reports
  • Demonstrate the proper use of the applicable checklists

Content

Section 1: Introduction to the Training/Course

Section 2: Quality Systems, Process Approach and QMS Standards

Section 3: AS9100 Rev C explanation (including ISO 9001:2008, and additional requirements, with emphasis on changes from AS 9100 Rev B to Rev C) Note:- Special topics covered include project management, risk management, configuration management, organizational performance objectives, customer satisfaction determination with the added emphasis on quality, OTD, etc.

Section 4: Training for Internal Auditing for AS 9100 Rev C as per guidelines of ISO 19011:2002 and AS 9101 Rev D.

Section 5: Exercises, Practical Examples, etc

Section 6: Internal Auditors’ Post Course Test for 30 minutes (Objective Type)

Who Should Attend

Course is best suited for Top and Middle Management, of Aviation, Space and Defense organisations.

Session Location

India

Duration

2 Day

Certificate

Intertek’s certificate of successful completion will be issued to delegates achieving 70 per cent or more marks in written examination, while the rest are issued attendance certificates.

Contact:

training.india.sc@intertek.com

If you are interested in attending this course, please fill out the form below. An Intertek representative will be in touch with you shortly. Thank you.